Vertical drilling machine with a diameter dilling up to 50 mm - 2A150

Vertical drilling machine with a diameter dilling up to 50 mm - 2A150

Model - 2A150

The machine can be used for drilling, boring, margin widening, gap widening, reaming, cutting of and facesin tool, repair, experimental and industrial shops.

The electric reverse mechanism of the engine of the main movement allows to make cutting of grooves by machine marking. The machine tool has the device for restriction of size of moving of a spindle on the given depth of processing.The machine tool is supplied with the special device for plating of the tool from a cone of a spindle.

TECHNICAL SPECIFICATION OF MACHINE
Maximum diameter of drilling, mm
-into steel
- into cast iron
40
50
Dimension of spindle cone morse4
Spindle gap, mm350
Maximum motion of spindle, mm320
Distance from end of spindle to table, mm50-600
Maximum travel of table, mm450
Working surface of table, mm450 x 500
Maximum axial force, N1000
Maximum spindle torque NM200
Quantity of steps of speeds of spindle12
Spindle rotational speed, rpm45...2000
Quantity of steps of mechanical submission of spindle6
Spindle feed rates, mm/r 0,1...1
Drive . Overall Dimensions and Mass of the table
Mains
- type of current
- frequency, Hz
- voltage, v
alternative three phase
50
380
16. Main drive electric motor power, KWT3,0
17. Number of electric motors on the machine3
Overall dimensions (LxBxH), mm1200x800x2500
Machine mass, kg1700